Changes between Version 1 and Version 2 of E1-to-RJ45

Timestamp:

04/08/09 20:46:52 (4 years ago)

Author:

kenny

Comment:

Images!

E1-to-RJ45

@@ -17 +17 @@
 Take your cable and cut off one of the RJ45 connectors.  Now use a ruler and make a slice so you can strip around 15 cm from you cable.
 
-# FIXME images
+[[Image(IMG_0960-1.JPG, 15%)]] [[Image(IMG_0960-2.JPG, 15%)]]
 
 '''Two:'''
@@ -23 +23 @@
 Split the wires from your cable.  We need pin 1 and 2 for '''RX''' (green white/green) and pin 4 and 5 for '''TX''' (blue white/blue), you can use a multimeter if you are not sure that you got the correct wires.  Cut off the other wires we do not need them (yet).
 
-# FIXME images
+[[Image(IMG_0960-4.JPG, 15%)]] [[Image(IMG_0960-5.JPG, 15%)]] [[Image(IMG_0960-7.JPG, 15%)]]
 
 '''Three:'''
@@ -30 +30 @@
 We used heat shrink tube to stabilize our cable around the plugs.
 
+[[Image(IMG_0960-9.JPG, 15%)]] [[Image(IMG_0960-11.JPG, 15%)]] [[Image(IMG_0960-7.JPG, 15%)]]
+
 '''Four:'''
 
 Now you can put everything on the first part of the cable and assemble it.  Use a soldering-iron to fixate the each of the two pins of the plug with your wires.
 
-# FIXME images
+[[Image(IMG_0960-9.JPG, 15%)]] [[Image(IMG_0960-11.JPG, 15%)]] [[Image(IMG_0960-12.JPG, 15%)]] [[Image(IMG_0960-17.JPG, 15%)]]
 
 '''Five:'''
@@ -40 +42 @@
 Repeat step '''three''' and '''five''' to build the second plug.
 
-# FIXME images
+[[Image(IMG_0960-19.JPG, 15%)]]
 
 '''Done.'''